47
9. Operation
Pay attention to the “Safety instructions” section!
a) Attaching/changing the nozzle
Insert the desired nozzle as far as it will go into the hot air nozzle (4 nozzles of various sizes/shapes are included in
the delivery for the air outlet). Then you can fix the nozzle to the hot air nozzle with the mounting screw.
Important, caution!
The nozzle heats up when the 4-in-1 rework station is in use. Risk of burns! Never change the nozzle when
it is hot. Always wait until the nozzle and the entire hot air nozzle have cooled down completely.
Do not use force to turn and tighten the mounting screw!
Depending on how the hot air nozzle will be used, you can also use the hot air nozzle without an attached nozzle (e.g.
when you need to heat large areas).
b) Switching on/off
Use the on/off switch (7) on the front of the 4-in-1 rework station to switch the workstation on (“I” position) or off (“O”
position). After the workstation has been switched on, the display will switch on and show the welcome message for
a few seconds. It will then show the normal display.
