Tone TOUCH 02, Оригинальное руководство пользователя

Страница: 25 / 30

25
SERVICE
Enter programming (see ”ENTER PROGRAMMING”).
Select “Service”. Enter password – (3926).
Select Error Messages to display and reset error messages. Press Finish to return to Service Menu. Press the Coun-
ters key to view water usage and number of cycles information. Service cycles may be reset. Press Finish to return to
Service Menu.
Press Filtration to activate or reset filter tracking. Filter capacity may be selected from sizes commonly used in the
beverage industry. Press Finish to return to Service Menu.
Password is non-changeable.
Press finish to go back to the Programming/Service menu. Press Finish again to return to the main/beverage select
screen.
BREWER PARAMETERS
This section of the code provides access to enable configuration of the brewer according to the options installed during
equipment manufacture.
Selections made in this section determine items available for calibration and for use in a brew recipe. Note that inac-
curate selections made in this portion of the code can create the appearance of equipment malfunction and therefore
the password for this section will not be provided in the instructions with the equipment.
Enter programming (see ”ENTER PROGRAMMING”).
Select Brewer Parameters and enter password – (5639).
All choices shown may be changed by repeatedly touching the appropriate button until the correct option is displayed.
1 or 2 brew valves may be selected. Recipes may then specify using 1 or both valves and calibration is allowed for both
choices.
Hot Bypass may be set as installed or not installed. Setting as installed allows use of hot water bypass in recipes and
allows calibration of the valve. If turned on without an actual valve, recipe would be short any programmed bypass.
Cold Dilution may be set as installed or not installed. Setting as installed allows use of cold water bypass in recipes and
calibration of the valve. If turned on without an actual valve, recipe would be short any programmed bypass.
Hot dispense valve is for using a hot water valve to control dispensing pre-measured volumes of hot water. A push and
hold feature is automatically enabled when this feature is selected.
The heating circuit may be programmed for either a solid state device which would allow pulse heating or for a mecha-
nical relay which would not but would be a more economical choice.
Press finish to go back to the Programming/Service menu. Press Finish again to return to the main/beverage select
screen.