08
color coding of each conductor at the elec-
trical source. For models without a cord, re-
move the rear top cover then the rear panel
and feed the cord through the strain relief.
Connect cord to the terminal block as indi-
cated in the appropriate diagram above.
▪
Ensure power switch on rear of brewer is
in the off position. Connect brewer to power
source and verify voltage at terminal block.
Replace rear panel and top cover. If plumb-
ing has been hooked up, brewer is ready for
Initial Set-Up. If not, disconnect brewer from
power source.
WARNING
Electrical connections must
be made as specifi ed above.
Failure to follow these instruc-
tions can result in personal in-
jury, property or equipment
damage.
NOTE:
This electrical service consist of 2
current carrying conductors (L1 and Neutral)
and a separate conductor for earth ground.
WARNING
Before servicing or opening
this device make sure the
brewer is disconnected from
power by pulling its plug. The
service technician has to see
the pulled plug during the
whole service operation.
BLACK NEUTRAL GREEN/
L1 N YELLOW
3.4 INITIAL SET-UP
▪
Insert an empty brew basket into the brew
rails.
▪
Place an empty server or other appropri-
ate vessel on the base below brew basket.
▪
Ensure power switch at lower right of
brewer is in the off position.
▪
Connect the brewer to power source pre-
pared previously, see Electrical Connection.
▪
Ensure water supply has been connected
and is turned on.
▪
Turn on the power switch on rear of brew-
er. Water will begin fl owing into the brewer
tank.
▪
Flow will stop when full.
▪
Tank will begin to heat.
▪
Hold a cup below faucet and operate han-
dle briefl y to dispense water and remove
any air from the line.
▪
Water calibration volumes have been set
at the factory and do not normally require
adjustment.
▪
Select a brew cycle from the available rec-
ipes in the brewer and activate it (See HOW
TO BREW if unsure how).
▪
If the brewer is up to temperature the cy-
cle will begin right away. If not heating will
complete fi rst.
▪
Once the test brew cycle completes suc-
cessfully, the brewer is ready for use as per
the instructions.
▪
If adjustments are needed to recipes, max
set point, calibrations, or other items, see
the appropriate sections of the PROGRAM-
MING portion of the manual.
▪
Repeat Initial set-up with sidearms.
INITIAL USE
