Tone 90600, Инструкция по установке и эксплуатации

Страница: 5 / 22

05 05 05
▪
In order to ensure the e ciency and correct
functioning of the appliance, it is necessary
to follow the instructions provided by the
manufacturer and to carry out its ordinary
maintenance.
▪
The appliance shall be installed so that the
highest surface is at least 1 metre high.
▪ The appliance shall be placed horizontally
(use level) by adjusting its feet to ensure a
safe use.
▪
The temperature range of the environment
surrounding the appliance shall be included
between 5°C and 30°C. In case the appli-
ance is tempo- rarily placed in an environ-
ment where the temperature is below 0°C,
contact a local Technical Service authorized
by the manufacturer.
▪
The machine shall be placed on a surface
guaranteeing secure support.
▪
The machine must be connected exclu-
sively to an appropriate cold drinking water
source, in compliance with national norms
and rules. The pressure of the incoming
water must be between 0.138 MPa and 0.3
MPa. If this requirement is not met, consult
the manufacturer.
▪
A shut-on tap must be installed between
machine water hose and water system to
block water fl ow in case of necessity.
▪ When installing the appliance, use exclu-
sively the current set of junctions provided
with the appliance itself.
WARNING DUE TO
UNAUTHORISED REPAIR!
Faulty repairs can result in
damage to the appliance.
▪ Repairs should be carried out only by au-
thorised customer service centres.
▪
If you cannot correct a fault with the aid
of the steps described in these operating
instructions, please refer to your authorised
dealer.
WARNING BEFORE
SERVICING OR OPENING
this device make sure the
brewer is disconnected from
power by pulling its plug. The service
technician has to see the pulled plug during
the whole service operation.
▪
The electric safety of the machine is
achieved only when the machine is correctly
connected to a grounded electric system.
▪ The user shall arrange electric, waterand
draining systems in a suitable position to
allow correct machine installation.
▪ The installer cannot modify the existing
system built by the user.
▪
If the electric supply cable is damaged, it
must be replaced by another cable provided
by the manufacturer or by its Technical
Service.
▪ For good machine functioning and
maintenance, it might be necessary to install
a water softener in order to avoid scale
formation. This must be evaluated by the
installer and the user shall leave a space for
the correct installation of a water softener,
following the instructions contained in its
manual.
Do not use water jet devices in
the area where Barista TOUCH
is installed!
Do NOT tilt Barista TOUCH
during operation! Max. tilt an-
gle < 2°.
Only to be operated by trained
personnel!