• Make the appropriate 120d programming changes as required. The 120d will initialize
automatically after the changes are entered.
If station lamps
11, 21, 33, 47, 53
persist, temporarily remove power from the 120d console for at
least 30 seconds, then reapply it.
If screen 28 is showing continuously:
• Verify that there is a SPID number entered for Terminal #2.
• Make the appropriate programming changes. Layer 2 should initialize as shown in screen
29.
If screen 29 is showing continuously:
• Verify that the correct SPID number is entered in the 120d's SPID Program for Terminal #2.
If necessary verify the number with a local telco customer support rep.
• Make the appropriate 120d programming changes if required. Layer 3 should initialize as
shown in screen 30.
The station lamp states shown below are a special case. Since the success or failure of fully
initializing Terminal #1 drives the LED Line Diagnostic Display, the following is shown whenever
Terminal #2 initializes fully but Terminal #1 doesn't:
11, 21, 33, 41, 53
• Verify that the correct SPID number is entered in the 120d's SPID Program for Terminal
#1. If necessary verify the number with a local telco customer support representative.
• Make the appropriate 120d programming changes as required. Layer 3 should initialize
and the LED Line Diagnostic display will clear automatically.
120d Call Origination Checkout
Press any DSS button that has already been programmed. When this is done, the following will be shown:
followed by:
Only if the called party answers, the display will update to:
Press the RELEASE button, then proceed to 120d Call Termination Checkout (page 88).
13-102633 Rev. H
Page 87
Tone Commander 40d120 Installation Instructions
DIAL Call Setup
Bill Smith
XX:XX
Screen 31
DIAL Ringing
Bill Smith
XX:XX
Screen 32
TALK Outgoing
Bill Smith
XX:XX
Screen 33
Содержание 40d120
