Tone Commander 40d120, Руководство по установке

Страница: 75 / 142

Console Programming Issues
Console #1
·
Press the MAINT key to enter Maintenance Mode.
·
Select SETUP.
The Setup menu will be displayed.
·
Set up the loops as in the Shared Call Appearances section for console #1 above.
·
Select KEYS.
·
Press the RING DLY button located between the TIME and CALL FWD buttons.
Ring delay information will be displayed.
·
Select EDIT.
Press the right arrow (-->) button repeatedly until the FUNCTION field reads “Not Used”.
·
Select DONE.
·
Select EXIT to return to the Setup menu.
IMPORTANT – As a precaution, the RING DLY key is removed from the main attendant’s console to
prevent inadvertent activation of the ring delay mode at this console.
Console #2
·
Press the MAINT key to enter Maintenance Mode.
·
Select SETUP.
The Setup menu will be displayed.
·
Set up the loops as in the Shared Call Appearances section for console #2 above.
·
Select TIMER.
The Ring Delay timer should be displayed. If not, press NEXT repeatedly until it is displayed.
·
Select EDIT.
·
Enter the desired ring delay interval.
Valid values are 1-999 seconds.
·
Select DONE.
·
Select EXIT to return to the Main menu.
IMPORTANT – Ring delays will only apply: 1) to call appearances that are programmed in the loops
program as Terminate (T), 2) while the status lamp above the RING DLY key is
illuminated, and 3) if the Ring Delay timer is programmed with a value greater than 6
seconds (the interval of one ring cycle).
13-102633 Rev. H Page 75
Tone Commander 40d120 Installation Instructions