Configuration Sheet Preparation
The configuration sheets attached to the back of this manual (starting on page 133) should be filled in with
the setup information for this installation. Instructions for each configuration sheet table, and sample
configuration sheets, are included in this chapter. Sample information is printed in
italic block
font
.
Please leave a copy of the configuration sheets on site.
System Setup
·
Press the MAINT key to enter Maintenance Mode.
·
Select SETUP.
The Setup menu will be displayed.
SPID, PDN, and C.O. Switch Type
Lucent Custom ISDN lines may be configured for either multipoint or point-to-point operation. Multipoint
lines can have multiple terminal devices connected to the same ISDN line. Point-to-point lines can have
only one terminal device connected to the line.
National ISDN lines are always multipoint.
The 40d may be connected to either a point-to-point or multipoint ISDN line. A 120d console configured for
60 stations may use either a point-to-point or multipoint line; a multipoint line configuration is required for
120 stations.
Consoles must be programmed with 10-digit
S
ervice
P
rofile
Id
entifier (SPID) numbers obtained from your
local telephone company. The SPID uniquely identifies the console when it is connected to the network.
The 40d has one SPID. Each 120d may have one or two SPIDs; two are required for more than 60
stations. In this application, the 120d appears as two distinct ISDN terminals to the network, each having
60 call appearances.
Additionally, the 40d console must be programmed with a
P
rimary
D
irectory
N
umber (PDN).
Configuration Sheet
Fill out Configuration Sheet #1 (page 133) with the PDN for the 40d console, and SPID numbers for the
40d and all 120d consoles. Check the appropriate ISDN Version box.
13-102633 Rev. H
Page 43
Tone Commander 40d120 Installation Instructions
MAINTENANCE MAIN MENU
NAMES
TIME
STATS
SETUP
DIAG
EXIT
[SETUP]
SPID
KEYS
QUEUE
TIMER
LOOPS
EXIT
National ISDN
For National ISDN lines, the SPID format should consist of your 10-digit PDN
(Including area code), followed by “0101”.
Lucent
Custom ISDN
For Custom ISDN lines, the SPID format should consist of “01” + the 7-digit
PDN (excluding area code) + “0”.
IMPORTANT
– Although a SPID number is not required for a point-to-point ISDN line, failure to enter one
for the 40d will not allow it to initialize. Contact your service provider if the SPID format does not work.
Содержание 40d120
