Tone Commander 40d120, Руководство по установке

Страница: 81 / 142

Select ORIG to originate a call. When this is done, dial tone should be heard and the following
shown in the display:
where STATE:02 = call initiation
Dial a directory number for a test call. The display should update to:
where STATE:03 = call proceeding SIGNAL:01 = ringback tone ON
Immediately following, the display should update to:
where STATE:04 = call delivered
Select DISC to disconnect the call; select EXIT to exit the test mode for CAXX; select another
call appearance by selecting NEXT or LAST; select TEST; then repeat the foregoing test call
procedures.
3. Call your telco support representative and ask the following:
• What are the call appearance assignments for the line?
• Has the terminal been programmed for both CACH and EKTS? It should be.
• If the line translations are updated, repeat the procedures in this section after such
changes have been completed.
If Screen 8 does not show and an error tone is heard each time the ORIGINATE button is pressed:
1. Enter the Maintenance Mode, select SETUP, select LOOPS, and view the loop assignments for
the 40d console.
2. Verify that at least one of the CAs that have been assigned as loops is programmed with either
ORIG or N/R. If none are programmed, program the highest numbered CA as N/R. Repeat the
procedures in this section.
13-102633 Rev. H Page 81
Tone Commander 40d120 Installation Instructions
STATE:02 CAUSE:000 SIGNAL:00 [CAXX]
ORIG HOLD RECONN DISC RELC EXIT
Screen 15
STATE:03 CAUSE:000 SIGNAL:01 [CAXX]
ORIG HOLD RECONN DISC RELC EXIT
Screen 16
STATE:04 CAUSE:000 SIGNAL:01 [CAXX]
ORIG HOLD RECONN DISC RELC EXIT
Screen 17
STATE:00 CAUSE:000 SIGNAL:00 [CAXX]
ORIG HOLD RECONN DISC RELC EXIT
Screen 14