TOHATSU MFS 15E Series, Руководство пользователя

Страница: 62 / 356

INSPECTION AND MAINTENANCE
60
10
*1"
z
" This procedure can be performed by end user (or dealer)
*2"
{
" This procedure shall be carried out by the dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the best
time for major maintenance procedures to be carried out.
ENOM00091-A
Engine oil replacement
Engine oil mixed with dust or water will
dramatically shorten the life of the engine.
ENOW00091-0
You may be injured due to high engine
temperatures if you fill engine oil just after
stopping. Changing engine oil should be
done after the engine has been cooled.
ENOW00092-0
z
Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper
limit marks of oil gauge, drain oil to level
lower than upper limit.
z
Be sure that outboard motor is in upright
and level position when checking or
changing oil.
z
Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is
found, or engine could be severely dam-
aged. Consult dealer.
z
Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
ENOW00090-0
Use of engine oils that do not meet these
requirements will result in reduced engine
life, and other engine problems.
Shift/
Throttle
Throttle cable
{
Check and replace if necessary
Throttle link*1
{ {
Check and adjustment
Shift cable
{
Check and replace if necessary
Shift link*1
{ {
Check and adjustment
Other
Power trim & Tilt
z
/
{ z
/
{
Check /Replenish Refer to P69
Warning system*1
{
Check
Stop switch
z z
Check
Meters
{ {
Check
Bolt, nut
{ {
Retighten
Sliding part
/rotation part
z z
Apply grease Refer to P70
Grease nipple
z z
Pump in grease Refer to P70
Outer equipment
z z
Check
Anode (engine)
{
Check and replace if necessary Refer to P68
Anode
(except for engine)
z
/
{
Check /Replace if necessary Refer to P68
Top cowl/Ratch
z
/
{
Check / Adjustment
Description
Inspection intervals
Inspection procedure Remarks
First 20
hours or
1 month
Every 50
hours or
3 months
Every 100
hours or
6 months
Every 200
hours or
1 year
Every 400
hours or
2 year
CAUTION
CAUTION
CAUTION
0)6(B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸴ᖺ㸯㸯᭶㸯㸶᪥ࠉ㔠᭙᪥ࠉ༗๓㸯㸮᫬㸯㸴ศ