172-65720MA-00 (FJ32-X+BD2) 22 Dec 2021
12
Disassembly/Reassembly of Components Inside the Trap Body
Part
During Disassembly
During Reassembly
Float Cover &
Screen 9, 10
Lift straight up and out while rocking
slowly
Align the arrows on the float
cover/screen and the body, insert with
the tab* on the bottom fitting into the
slot in the body; make sure the screen
does not stick out out of the body
(Figure C)
Float 3
Remove, being careful not to scratch
the polished surface
Insert, being careful not to scratch the
polished surface
Orifice Plug 6 Remove with a socket wrench
Consult the table of tightening torques
and tighten to the proper torque
Orifice Plug
Gasket 7
Remove the gasket
and clean sealing
surfaces
Replace with a new gasket; coat
surfaces with anti-seize
Orifice 4
Remove with a socket wrench
Consult the table of tightening torques
and tighten to the proper torque
Orifice Gasket
5
Remove the gasket and clean sealing
surfaces
Replace with a new gasket; coat
surfaces with anti-seize
Figure C
Disassembly/Reassembly of Components Inside the Connector Body
Part
During Disassembly
During Reassembly
Screen Holder
22
Remove with a socket wrench
Consult the table of tightening torques
and tighten to the proper torque
Screen Holder
Gasket 21
Remove the gasket
and clean sealing
surfaces
Replace with new gasket; coat surfaces
with anti-seize
Screen 20
Remove with needle-nose pliers
Insert securely into the connector body
Table of Tightening Torques
Part Name
Torque
Distance Across Flats
N
m
(lbf·ft)
N
m
(in)
Orifice 4
30
(22)
10
(
3
/
8
)
Orifice Plug 6
80
(59)
24
(
15
/
16
)
Air Vent Valve Seat 13
35
(26)
19
(
3
/
4
)
Cover Bolt 15
50
(37)
17
(
21
/
32
)
Screen Holder 22
150
(110)
38
(1
1
/
2
)
Bolt 23 (Trap Body 1/Connector
Body 19)
39
(28)
14
(
9
/
16
)
NOTE: -Coat all threaded portions with anti-seize.
-If drawings or other special documentation were supplied for the
product, any torque given there takes precedence over values
shown here.
(1 N
m
10 kg
cm)
