172-65720MA-00 (FJ32-X+BD2) 22 Dec 2021
19
Options
The options shown below are available for this product on
request. Please compare with the product you received.
Options for Area A (standard: without drain plug)
With Drain Plug
Part Name
Torque
Distance Across
Flats
N
m
(lbf
·
ft)
mm
(in)
Drain Plug
35
(26)
21
(
13
/
16
)
(1 N
m
10 kg
cm)
Options for Area B (screen holder)
With Blowdown Valve (TLV-BD2)
Always wear eye protection and heat-resistant gloves when operating the
blowdown valve.
Failure to do so may result in burns or other injury.
When operating the blowdown valve, stand to the side well clear of the outlet
to avoid contact with internal fluids that will be discharged. Operate the valve
slowly and surely, taking care to avoid the area from which internal fluids are
discharged and any fluids deflected off piping or the ground etc.
Failure to do so may result in burns or other injury.
Do not tighten the BD2 valve or the BD2 valve seat in excess of the
appropriate tightening torque.
Over-tightening may cause breakage to threaded portions, which may cause burns,
other injuries or damage.
Do not excessively loosen the BD2 valve when opening the blowdown valve.
The valve stopper pin installed to prevent the BD2 valve from being removed may
break and internal pressure may result in the BD2 valve being blown off, leading to
injuries, damage and fluid discharge, causing burns.
No.
Part Name
1
BD2 Valve
2
BD2 Valve Seat (Screen Holder)
3
Screen Holder Gasket
4
Screen
5
Valve Stopper Pin
6
Discharge Hole
TLV Blowdown Valve: BD2
The BD2 blowdown valve, installed in the screen area of the connector body, uses the
trap’s internal pressure to blow any condensate, steam, dirt or scale accumulated
around the screen area out to atmosphere.
CAUTION
