Titan Attachments 191587, Руководство оператора

Страница: 25 / 50

25
working condition to avoid driveline
entanglement and projectiles flying off
of the driveline.
•
Always disconnect driveline from power
take- off shaft before servicing
underside of cutter. The tractor can be
started with power take-off engaged.
•
Do not use cutter as a fan. Cutting
blades are not properly designed or
guarded for this use.
WARNING
To avoid serious injury or death:
•
Do not operate and/or travel across
inclines where tractor and/or
implement can rollover. Consult your
tractor’s manual for acceptable inclines
the tractor is capable of traveling
across.
•
Never carry riders on the implement or
power machine. Riders can obstruct the
operator’s view, interfere with controls,
be pinched by moving components,
become entangled in rotating
components, struck by objects, thrown
about, fall off and be run over, etc.
• A rotating driveline must not exceed an
angle of 25 degrees up or down, and
never engage a driveline while at an
angle exceeding 25 degrees up or down.
The driveline can break and send
projectiles.
• Do not operate a broken or bent
driveline. Such a driveline will break
apart while rotating at high speeds and
can cause serious injury or death.
•
Always remove the implement from use
until the damaged driveline can be
repaired or replaced.
• Always follow “ Tractor Shutdown
Procedure ” provided in this manual
before dismounting the tractor.
•
Always disengage power take-off before
lifting cutter fully up. Never operate
cutter in the raised position. The cutter
can discharge objects at high speeds.
• Do not use implement as a man lift or
work platform. It is not properly
designed or guarded for this use.
•
Perform scheduled maintenance. Check
for loose hardware, missing parts,
broken parts, structural cracks, and
excessive wear. Make repairs before
putting the implement back into service.
•
Do not use implement to lift objects; to
pull objects such as fence posts, stumps,
etc.; or to push objects. The unit is not
designed or guarded for these uses.
•
Select a safe ground speed when
transporting. Never travel at a speed
which does not allow adequate control
of steering and stopping, and never
exceed 20 mph (32.2km/h) with
attached equipment. Rough terrain
requires a slower speed.
•
Buildup of debris around moving
components and gearboxes is a fire
hazard. Keep rotating parts and
gearboxes free from debris to avoid
serious injury and property damage.
•
Improper oil level can cause bearing
failure and be a fire hazard. Maintain
proper gearbox oil level to avoid serious
injury and property damage.
•
Do not exceed rated cutting capacity of
your cutter. See
specifications &
capacities for specified cutting
capacity. Exceeding rated cutting
capacity can damage drive
components, cutter blades, and deck
components.