Titan Attachments 191587, Руководство оператора

Страница: 33 / 50

33
thick.
d. Always grind cutting edge so
end of blade remains square
to cutting edge and not
rounded.
e. Do not sharpen back side of
blade.
f. Both blades should weigh the
same with not more than 1 ½
oz. difference. Unbalanced
blades will cause excessive
vibration which can damage
gearbox bearing and create
structural cracks.
Refer to Figure 4-5:
7.
Carefully check cutting edges of blades in
relation to blade carrier rotation to
ensure correct blade placement. Blade
Rotation is counterclockwise with cutting
edge leading.
Figure 4-4: Cutter Blade Assembly
Refer to Figure 4-4:
WARNING
To avoid serious injury or death:
A locknut that has been removed can lose its
thread locking properties. Reusing a used locknut
can result in a thrown blade. Always use a new
locknut when installing blades.
IMPORTANT:
Examine blade bolts (#1) and flat washers (#2)
for excessive wear and replace if worn.
8.
Insert blade bolt (#1) through blade (#6),
blade mount bracket (#4), and plain
washer (#2). Secure blade with a new
locknut (#3) and torque to 400 ft.-lbs.
9.
Replace access rubber cover (#5).
10.
If replaced blade mount bracket (#4), nut
(#7) on gearbox output shaft should be
torque to 450 ft.
Figure 4-5
: Counterclockwise Blade Rotation