Titan Attachments 191587, Руководство оператора

Страница: 24 / 50

24
Take-off shaft and cutter gearbox shaft.
6. Check driveline guards to make
certain they are in good condition an
in place. Carefully raise and lower
implement to ensure that the
drawbar, tires, and other equipment
on the tractor do not contact cutter
frame or driveline.
7. With cutter resting on solid supports,
power take-off disengaged, and blade
rotation completely stopped:
•
Check for and remove foreign objects
wrapped around blade spindles.
• Check for nicked, bent, broken, and
worn cutting blade. Replace or
sharpen blades as required. Refer to
“ Cutter Blade Maintenance ” on
page 32.
9.
Remove solid supports from under
the deck.
10.
Verify cutter is set at the correct
cutting
height. See “ Deck Leveling &
Cutting Height ” on page 21.
The remaining inspections are made by
engaging the power take-off to check for
vibrations.
WARNING
•
To avoid serious injury or death:
Stop power take-off immediately if
vibration continues after a few
revolutions during start-up and anytime
thereafter. Wait for all components to
come to a complete stop before
dismounting from tractor to check for
probable causes. Make necessary
repairs and adjustments before
continuing.
• Some tractors are equipped with two
power take-off speeds. Be certain your
tractor’s power take-off shaft is set-up
to operate at 540 rpm. Do not exceed
540 rpm power take-off speed or
equipment breakage may result.
11.
Start tractor, set throttle to idle or
slightly above idle, and slowly engage
power take-off, initial start-up
vibration is normal and should stop
after a few revolutions. Stop power
take-off rotation immediately if
vibration continues.
12.
Once the cutter is running smoothly,
increase tractor power take-off speed
to 540 rpm. Stop power take-off
rotation immediately if vibration
occurs.
13.
Investigate cause of vibration and
make repairs before putting cutter
back into service.
SAFETY INFORMATION
WARNING
To avoid serious injury or death:
•
Never place hands or feet under the
deck or attempt to adjust to the cutter
with power take-off engaged. Cutter
blades rotating at high speeds cannot be
seen and are located close to the deck
sides.
•
Do not engage power take-off while
hooking-up or unhooking the driveline,
or while someone is standing near the
driveline.
A person’s body and/or
clothing can become entangled in the
driveline.
•
Do not use a power take-off adapter.
The adapter will increase strain on the
tractor’s power take-off shaft causing
possible damage to shaft and driveline.
It will also defeat the purpose of the
tractor’s power take-off shield.
•
Rotary Cutters can discharge objects at
high speeds; therefore, the use of front
& rear safety guards is mandatory with
this cutter. Stop blade rotation if
bystanders are in or around the area. It
is recommended that a safety shield be
placed between the operator and cutter
on an open-air tractor.
•
All guards and shields must be installed
and in good working condition while
operating the implement.
•
Tractor power take-off shaft shield,
driveline shields, and gearbox shaft
shields must be installed and in good