© TIMYO B.V.
TIMYO USER MANUAL EN SKO52021V2
PAGE 40
Short-press twice (interval time is less than 0.5 S) to exit the main interface, or select 'BACK' -> 'EXIT'
to return to the main interface. The data is not automatically reset when the e-bike or the display is
switched off.
Setting the maximum speed
Set the maximum speed down by pressing .
Up by pressing .
In the Netherlands, the legal requirement is that an e-bike may be assisted up to 25 km/h. If you
exceed the speed with the e-bike, the pedal assistance will stop. You can continue to cycle, but you
will no longer be assisted. As soon as you get above 25 km/h, the e-bike will not pedal heavier to get
you below 25 km/h. Because there is a freewheel engine in this model, you pedal as if you were on
an e-bike without pedal assistance.
Pay attention!
This menu is only for adjusting the speed limit downwards. If you try to boost
the e-bike, the consequences are at your own risk. Do not modify the technology of the
e-bike in any way. Treating the e-bike in any way to increase performance or speed may
lead to legal problems and/or make the e-bike less safe to ride.
Setting the wheel diameter
Set the diameter of the wheel using and .
Pay attention!
Default setting: 700 c. There should be no deviations from this rule, as this
would render the computer system ineffective.
Set km/h or mph
With and you choose kilometers per hour or miles per hour.
Setting the drive mode
Use or to select the desired drive mode.
Switch the assist on or off.
Press the MODE button on the control panel on the left side of the steering wheel for 2 seconds.
As soon as the screen is switched off, the e-bike will no longer assist you.
Do you want the screen to be on but stop the assist? Set the assistance level to 0. The computer
system then continues to measure distances and speeds.
Pay attention!
The display will turn off automatically after 5 minutes at a speed of 0 km/h.
!
!
!
