© TIMYO B.V.
TIMYO USER MANUAL EN SKO52021V2
PAGE 36
5.3.25 Error code definitions
The display can show the errors of an e-bike. If an error is detected, one of the following
error codes is displayed.
Note:
Read the description of the error code carefully. If you see the error code, first restart
the system. If the problem is not resolved, contact your dealer.
i
07
Overcurrent protection.
1. Remove the battery.
2. Replace the battery.
3. Contact your dealer if the
problem persists.
08
Error with the Hall sensor signal in the
engine.
Contact your dealer.
09
Error with the engine phases
Contact your dealer.
10
The temperature in the engine has reached
its maximum protection value.
1. Turn the system off and leave the e-bike
cool down.
2. Contact your dealer if the
problem persists.
11
The temperature sensor in the engine
has an error
Contact your dealer.
12
Error with the current sensor in the
controller.
Contact your dealer.
13
Error with the temperature sensor in
the battery.
Contact your dealer.
14
The protection temperature in the
controller has reached its maximum
protection value.
1. Turn the system off and leave the e-bike
cool down.
2. Contact your dealer if the
problem persists.
15
Error with the temperature sensor in the
controller.
Contact your dealer.
21
Speed sensor error.
1. Reboot the system
2. Check that the magnet is on the spoke is
aligned with the speed sensor and that the
distance is between 10 mm and 20 mm.
3. Check that the connector of the
speed sensor is correctly connected.
4. Contact your dealer if the
problem persists.
Number
Definition
Solution
04
The power supply throttle does not return to
the correct position.
Check that the throttle throttle is back in the correct
position. If the situation does not improve,
install a new throttle. (only if this function is available)
05
Power supply error
Check the plug or cable of the
throttle whether they are properly attached
2. Disconnect the throttle. If the problem
still occurs, please contact your
dealer (only if this function is available)
