Timken ROLLON CTU 220-1I, Руководство пользователя, Страница: 5 / 48

UM-3
Cobot Transfer Unit
It is mandatory to carefully consult this manual
prior to incorporating the Partly Completed Ma-
chinery. The information contained in the follow-
ing manual is for highly qualified and certified
personnel, possessing adequate competence in
incorporating the partly completed machinery.
Precaution in installation and handling opera-
tions. Significantly heavy equipment.
When handling the actuator, always make sure
that the support or anchoring surfaces do not
leave room for bending.
Before handling, stabilize the axis by securely
blocking its mobile parts. When handling axes
with vertical translation, it is mandatory to make
sure the carriage is at the corresponding lower
limit switch. Consult the image below and the
pertinent chapter.
Do not overload. Do not subject to bending forces.
Do not leave exposed to weather.
The system was designed following the agree-
ments and the instructions provided by the
client. The manufacturer cannot be considered
responsible for any consequences derived from
improper use or any use other than the purpose
the system was designed for, or derived from
failure to comply, during incorporation phases,
with the rules of Good Technique and with what
is indicated in this manual.
To avoid damage, do not work on this machinery
with unsuitable tools.
Warning: moving parts. Do not leave objects on
the axis.
Make sure that the system is installed on a level
floor surface.
During use, carefully comply with the specific
performance values stated in the catalog
Make sure all electrical parts remain dry. In case
of contact with water, switch the power off im-
mediately.
Prevent dust from entering the electrical cabinet.
The images in this manual are to be considered
merely an indication and not binding
; therefore,
the supply received could be different from the im-
ages contained in this manual, and Rollon S.p.A
has deemed it useful to insert only one example.
Systems supplied by Rollon S.p.A. are not
designed/envisaged to operate in ATEX envi-
ronments.
Hazardous voltage.
Turn power off before commissioning or ser-
vicing.
Motor and gearbox generate heat during operation.
Do not touch the motor/gearbox while in operation
or immediately after operation, as prolonged con-
tact can cause discomfort. Cool the motor/gearbox
by powering off the system and wait.