Tiger TRIPLE FLAIL JD5 M T4F Series, Монтаж и эксплуатация

Страница: 39 / 240

ASSEMBLY
© 2020 Alamo Group Inc.
ASSEMBL
Y
Assembly Section
2
-
9
Remove appropriate plugs in the fenders, roof and front of the tractor to provide access holes
for the perimeter guarding fasteners. Refer to the Parts Section for the specific parts and
fasteners needed for your tractor.
JOYSTICK CONTROL MOUNTING
Mounting the adjustable joystick control requires that the right armrest be modified and an
additional bracket attached. Remove the screw from the back of the armest. This will allow the
armrest to be removed. Once the armrest is removed, line up the front of the armrest with the
front of the armrest bracket, as shown in the photo below. Mark the armrest where the holes
pass through the armrest bracket. Two 7/16” holes must be drilled through the armrest so that
the bracket can be secured. After the initial 7/16” holes are drilled, on the outside of the armrest
the hole must be cut to a larger diameter up to the metal plate in the armrest, so that a hex nut
can be fastened to the capscrew which will secure the bracket. Install the armrest bracket on the
armrest with the hardware shown in the Parts Section. Once the bracket is installed, re-attach
the armrest to the seat using the existing hardware previously removed. Then install the joystick
in the bracket with the machine screws shown in the Parts Section. Route the lift valve wires
from the switchbox through the cab and out the back window. Cover with conduit and secure with
ties or clamps as necessary.