Tiger 370 CNC--MR, Руководство по эксплуатации и обслуживанию

Страница: 107 / 180

MEP S.p.A.
6--40 97
Use and maintenance manual TIGER 370 CNC--MR
CN 1 VICE
CN 1 VICE
Vice with 12 poled coupling
Pin N° Signal Signal description
1 +V24 +24 Vdc power supply
2 0V24 Reference mass for the TEN, IEN isolated entrances
3 OK
Driver OK (10 Wmax --- 100 Vmax --- 100 mAmax).
Exit relays indicating the state of the drive.
---Contact closed at+24Vdc in normal functioning conditions.
--- Contact open in alarm conditions of the system
4 TEN
TORQUE ENABLE, signal of torque enabling
Isolated digital entrance, active at +24Vdc.
With the signal active the drive is enabled to provide torque to the motor.
In absence of this signal the motor frees itself immediately.
5 IEN
INPUT ENABLE enabling signal of enabling of the speed reference.
Isolated digital entrance, active at
+24Vdc.
With the signal active the drive enables the reading of the speed set---point
present at the REF and REF/ analogical entrances.
In absence of the signal the reading of the set---point is disabled and attributed
to
The value of 0V. With the motor in movement, the absence of the IEN signal
causes the functioning motor to stop on the set ramp; the ramp ended the
motor is held in torque and in position.
6 REF
External analogical reference signal
±
10V of the speed.
Entrance not invertible
7 REF/
External analogical reference signal
±
10V of the speed
Entrance invertible
8 0V
Reference mass of the
REF\, REF & EXTREF signals.
9 EXTREF
EXTERNAL TORQUE REFERENCE.
Analogical entrance (0
÷
10
V
) of torque limitations distributable to the motor:
Entrance at 0V = no torque; Entrance not connected 0+10V = maximum
torque
10 PULSE Nonoperating
11 DIR Nonoperating
12 CONCLR Nonoperating