15
Tidal Fit START-UP cont...
TESTING THE GFCI BREAKER cont...
NOTE:
When power is turned on, your pool is automatically programmed
to start circulating water through the circulation pump. Each pump and/
or blower will come on consecutively for approximately 1 minute to au-
tomatically purge the system. Adjust your temperature by pressing the
up button on your touch pad until the desired temperature is displayed.
This setting will allow your pool to heat to the set temperature.
CAUTION:
If water is not noticeably coming from your pool jets during
the automatic purge, turn on the high speed pump. If water is still not
coming from the jets, the pump needs to be manually primed, following
the steps below.
PRIMING THE PUMP
1) Turn off power at electrical service panel.
2) Locate and loosen one of the pump plugs on each pump by turning it
counterclockwise one half of one turn.
3) Allow air to escape from fittings. When a steady stream of water flows
from the pump plug, close it by turning it clockwise until tight.
4) Turn on power at electrical service panel.
5) Check once more to make sure that water is flowing from the jets dur
-
ing auto purge. If so, continue. If no water is coming from your spa jets,
please call your Artesian dealer for further assistance.
WATER PREPARATION
NOTE:
Before putting your new pool into operation, understand that
preparing your new water is an important part of maintenance. Failure
to properly prepare your water can result in substantially decreasing
the life of the components and may void your warranty in severe cases.
Your Artesian dealer should have a start-up and maintenance kit avail-
able for you when you receive your pool.
Содержание Premium EP-14
Страница 1: ...Part 11 0096 11...
Страница 2: ...This manual covers your new 2009 TidalFit...
Страница 13: ...9 60Hz GFCI WIRING DIAGRAM...
Страница 57: ...INTERIOR SPA DIAGRAM 53...