3
a. Install the receiver switch onto the servo mount beside the steering servo with 2 tap screws.
b. Install the steering servo onto the servo mount with four tap screws. (Note the output shaft
should be centered between the chassis frames.)
c. Install the throttle servo onto the servo mount with 4 tap screws. The mounting position is shown
in this manual.
d. Install the receiver above the space between two frame posts using supplied double-sided tape.
e. Install the receiver battery pack on the bottom of the chassis. Then secure the battery pack with
large zip tie.
f. Ensure all wires are securely connected to the receiver:
steering servo connector plug - into the channel 1 slot
throttle servo connector plug - into the channel 2 slot
battery switch connector plug - into battery slot.
Then thread the receiver antenna/wire through the antenna mount.
g. Thread the receiver antenna/wire all the way through the antenna tube and install the antenna
tube onto the mount. Place the supplies antenna tip over the top of the antenna tube to secure
the antenna/wire.
h. Then, use a small cable-tie or zip tie to organize the excess wiring from any high temperature or
moving parts.
1
INSTALLING THE RADIO GEAR
a
a
b
b
c
c
g
g
h
h
d
d
e
e
ff
Skip if already assembled in RTR version
