6
a. Use a hex driver to loosen the screws of the mount on the side of the body frames.
b. Install the supplied side guard wire into the mounts and re tighten the screws..
c. If you are unable to run the motorbike straight l, it may caused by improper set-up of the steering
servo linkage or the rear wheel may not be parallel to the front. To re-adjust the steering servo
linkage, repeat step 2a . To get the rear wheel parallel and achieve correct tension of the rear
drive chain, detach the 2.5mm screw on the rear end of the swing arm. Use you finger tip to feel
the best set-up of the tension of drive chain. The ideal set-up is around 2 mm range of
movement up and down. (Note: The rear tire and the swing arm must be parallel, if not, loosen
the 2.5mm screw on the right side of swing arm to parallel the rear wheel with the rear swing
arm.)
4
INSTALLING THE SIDE GUARD WIRE AND
ADJUSTING THE STABILITY
a
a
b
b
c
c
Detach the 2.5mm screw on the
rear end of the swing arm
Loosen the 2.5mm screw on the
right side of swing arm
Not Parallel
Parallel
After adjusting, tighten the
screw again.
Leave 2mm range of movement
up and down
