Cause
1. Fuel tank is empty
2. Contaminated fuel
3. Glow plug does not work
4. Glow plug igniter is not charged
5. Engine is flooded
6. Engine is overheating
7. Carburetor is incorrectly
adjusted.
8. Exhaust blocked
9. Air cleaner blocked
1. Idle speed set too slow
2. Air bubbles in fuel line.
3. Glow plug is fouled
1. Engine is flooded
2. Engine is seized
1. Brake setting is incorrect
2. Worn out of brake pad
1. Transmitter and/or receiver
batteries are dead or weak.
2. Transmitter has low range
3. Servo linkage not adjusted
properly.
4. Rear wheel and rear swing arm
are not parallel.
5. Steering Trim not adjust in the
neutral.
TROUBLESHOOTING
Solution
1.Add fuel the bike
2.Replace with new fuel
3.Replace the glowplug and see Step15
"PREPARING THE ENGINE" section.
4.Recharge the igniter
5. See Step16 "UNFLOOD AN ENGINE"
section.
6. Allow engine to cool, richen the "Fuel
Mixture"
7. Re-adjust carburetor, see
Step13"ADJUSTING CARBURETOR"
section
8. Check exhaust, remove blockage.
9. Check air cleaner, remove blockage
1.Adjust idle speed screw, see
Step13"ADJUSTING CARBURETOR"
section.
2.Check for leaks in fuel line.
3.Replace glow plug, see Step15
"PREPARING THE ENGINE" section.
1. See Step16 "UNFLOOD AN ENGINE"
section.
2. Examine engine for damage
1. See Step12 "ADJUSTING
THROTTLE/BRAKE LINKAGE" section.
2. See Step 3 "INSTALLING
THROTTLE/BRAKE LINKAGE" section
to replace brake pad.
1. Replace the batteries or recharge.
2. Fully extend transmitter and receiver
antenna.
3. See Step2 "INSTALLING STEERING
SERVO LINKAGE" section to re-build
and re-adjust the steering servo linkage.
4. See Step 4 "INSTALLING THE SIDE
GUARD WIRE AND ADJUSTING THE
STABILITY" section to adjust the rear
wheel.
5. See Step 10 "OPERATING RADIO-
STEERING FUNCTION" section to
adjust neutral position.
Description
Engine does not start
Engine star ts, but
then stalls.
Shaft starter will not
rotate.
No brake control
Motorbike is difficult
to control
THUNDER TIGER CORPORATION
http://www.thundertiger.com
JD6599
