thomann Stairville BS-280 R10 BeamSpot, Руководство пользователя

Страница: 16 / 40

7 Operating
7.1 Starting the device
CAUTION!
Risk of injury due to movements of the device
The head of the device can move quickly (pan, tilt) and can produce
very bright light. This is also valid immediately after you turn on the
device, when the device operates in automatic mode or under remote
control and when you turn off a DMX controller that is connected to the
device. Persons staying near the device could be injured or frightened.
Before you turn on the device and during the operation, always ensure
that nobody stays close to the device. If work has to be performed in the
area of movement or in the near vicinity of the device, it must remain
turned off.
Connect the device to the power supply to start operation. After a few seconds, the
fans start to work, the head moves to the home positions for rotation (pan) and incli‐
nation (tilt), the screen displays a start message. After a few more seconds, the device
operates in the last set mode.
7.2 Main menu
Press [MENU] to activate the main menu and select a menu item. If the desired menu
item appears in the display, confirm the selection with [ENTER] .
Use and to change the respectively displayed value. If the display shows the
required value, press [ENTER] and then [MENU] . To return to the main menu without
making changes, wait around 30 seconds.
All previous settings are retained even when you switch the device off and discon‐
nect it from the mains. To restart with default values, use the ‘RESET’ function.
Press [MENU] repeatedly until the display shows ‘Address’ . Press [ENTER] . Now you
can set the number of the first DMX channel used by the device (DMX address). Use
and to select a value between 1 and 512.
Make sure this number matches the configuration of your DMX controller.
If the display shows the required value, press
[ENTER] and then [MENU] . To return to
the main menu without making changes, wait around 30 seconds.
Press [MENU] repeatedly until the display shows ‘Channel Mode’ . Use and to
select between the following values: 15-channel or 21-channel. This setting is only
relevant if the device is being controlled via DMX.
If the display shows the required value, press
[ENTER] and then [MENU] . To return to
the main menu without making changes, wait around 30 seconds.
DMX address
Operating mode ‘DMX’
Operating
moving head
16