THERMOSALD UPSCR10030-M-V3, Руководство по эксплуатации и обслуживанию

Страница: 12 / 27

Pag. 12 Tot 27.
THERMOSALD UPSCR_M_V3
08/2000
(This operation is required whenever a temperature of 100°C/212°F needs to be reached automatically)
ENERGY CONTROL (THIS FUNCTION NEEDS TO BE ENABLED TO INCREASE REDUNDANCY, SELF-
CONTROL AND SYSTEM SAFETY BY INPUTTING MACHINE DATA F=1)
(this procedure is performed to allow the machine to automatically receive the energy transferred to the band during
operation. This function has been provided in order to increase system safety as, in many cases, it comes into action
with complex algorythms to identify faults and eliminate overheating which, under certain conditions, may lead to
dangerous situations).
•
Give the signal to pre-heat for 10 seconds
•
Start with the machine producing bags
•
NOTE: each time the pre-heating or sealing temperatures are changed, an automatic acquisition procedure needs to be
repeated.
WRITE DOWN THE MACHINE DATA
•
Fill in the chart in annex D
•
Press key RESET/MODE for 6 seconds. Keep it pressed until the operation has been completed: 100°C/212°F should
flash on the display.
•
WARNING!!! IN THE EVENT OF OVERHEATING CAUSED BY MACHINE PROBLEMS,
IMMEDIATELY RELEASE THE KEY