Thermo Scientific PARTISOL 2000, Руководство по обслуживанию

Страница: 29 / 96

Service Manual, Partisol Model 2000 Air Sampler
S
ECTION
3: S
ERVICE
P
ROCEDURES
P
AGE
3-1
Revision B.000
This section describes the service procedures required to maintain consistent opera-
tion of the Partisol Sampler. Additional maintenance procedures (such as cleaning the
PM-10 inlet) are contained in the Operating Manual. This section provides recom-
mended intervals for maintenance and calibration procedures. However, when
determining your own intervals for maintenance and calibration, you must take into
account the quality assurance guidelines of your specific monitoring organization and
any special local considerations.
Maintenance Procedures Interval Reference
Exchange large in-line filter 6 months Section 3.1.1
Exchange fuses As needed Section 3.1.2
Clean air intake filters 6 months Section 3.1.3
Inspect “V” seals during filter exchange Section 3.1.4
System leak test 3 months Section 3.1.5
Test batteries 6 months Section 3.1.6
Rebuild vacuum pump 18 months Rebuild kit
Calibration Procedures Interval Reference
Interface board calibration 1 year Section 3.2.1
Analog input calibration 1 year Section 3.2.2
Ambient air temperature calibration 1 year Section 3.2.3
Ambient pressure calibration 1 year Section 3.2.4
Mass flow controller calibration 1 year Section 3.2.5
3.1. M
AINTENANCE
P
ROCEDURES
This section contains maintenance procedures for the Partisol Sampler. Additional
maintenance procedures (such as cleaning the PM-10 inlet) are contained in the
Operating Manual.
3.1.1. E
XCHANGING THE
L
ARGE
I
N
-L
INE
F
ILTER
The large in-line filter prevents particulate matter from entering the sampler’s flow
controller and causing damage.
Tools Needed:
Phillips screwdriver
Needle nose pliers
Materials: Large in-line filter (R&P P/N 32-002643)
Section 3: Service Procedures