Thermo Scientific PARTISOL 2000, Руководство по обслуживанию

Страница: 42 / 96

Service Manual, Partisol Model 2000 Air Sampler
S
ECTION
3: S
ERVICE
P
ROCEDURES
P
AGE
3-14
Revision B.000
3.2.2. A
NALOG
I
NPUT
C
ALIBRATION
Please note that the following procedure must be performed after the interface board
calibration and before the temperature, pressure and flow calibrations.
Tools Needed: Multimeter with four-digit resolution
Materials: Analog calibration cable (R&P P/N 51-002604)
Follow these steps to calibrate the analog input:
1) If the Main screen is not currently displayed, press <Esc> until the
Main screen is shown (Figure 3-12).
2) The device must be in the Stop Operating Mode to perform an
analog input calibration. If the hardware is currently in the Run
Operating Mode, press <F4: Run/Stp> to enter the Stop Operating
Mode. The current operating mode is displayed in the upper
right-hand corner of the Main screen.
3) While in the Main screen, press <F5: Setup> and then <F2: Calib>
to access the Calibration screen (Figure 3-13).
4) Plug the 6-pin end of the Analog Input Calibration Cable supplied
with the sampler into the socket labelled “ANEMOMETER” on the
back of the Partisol hub unit (Figure 3-14).
Figure 3-12. Main screen.
4
Always wear appropriate
antistatic devices when
working with the system’s
electronics.
Basic Partisol Main Screen Stop
16:21 03 - Feb - 00 Curr:2 Status:OK
Stat Std Vol Valid Total Date
H1: DONE 24.143 24:00 24:00 02-Feb
S2: ON 16.342 16:21 16:21 03-Feb
S3: OFF 0.000 0:00 0:00 04-Feb
S4:
Edit Stats Storage Run/Stp Setup
Soft Function Keys in View Data Mode
Soft Function Keys in Edit Mode
Daily Today+1 + ++ Bksp >
- - - + ++ Bksp <
Unshifted
Shifted
Unshifted
Shifted
Edit Stats Storage Run/Stp Setup