Thermo Scientific Oretronic III, Руководство по эксплуатации и обслуживанию

Страница: 64 / 152

Operating the TMD
3-18 Operating the TMD Thermo Fisher Scientific
REC-4105 Rev L
SETUP? Y
C L I P D L Y
BAR SENS
BAR LEN
B E L T S PD
TIME DLY
TIME DUR
MAT
CODE
1.
Stop the conveyor belt.
2.
Bump the conveyor belt until a 10-ft (3-m) section of belt, without
splices or clips, is centered in the detection area.
There should not be a splice or clip within 4 ft (1.2 m) of the
receiver coil on the return side.
3.
Scroll to the high-level setup menu and put the TMD in Setup
mode (SETUP? Y).
4.
If your system uses a marking device, scroll to the TIME DLY
display and enter the time, in seconds, it takes for tramp metal to
move from the coils to the marking device. (Refer to Section
“Determining Timed Delay”)
Range: 0.1–9.9 seconds
Default: 1.0
5.
Scroll to the TIME DUR display and enter the duration of the
timed marking output in tenths of a second.
Range: 0.1–0.9 seconds
Default: 0.9
6.
If your system uses a belt clip detector, scroll to the CLIP DLY
display and enter the distance, in feet, from the clip detector to a
point six inches past the receiver coil. If no speed sensor is used,
enter the time needed to pass the belt splice. (Refer to Section
“Determining Clip Delay”)
If your system does not use a clip detector, enter 0 to turn off clip
detection.
If your system uses two clip detectors and the time required to pass
the belt splice is greater than 10.0 seconds, use the — — — on/off
mode. Above 10.0, the on/off mode is used with variable speed
belts where Clip Detector A input turns on the clip detector and
stays on until Clip Detector B input turns it off.
Range: 0.0–30.0 ft, 0.0 – 10.0 seconds, — — — turn
on/off mode
Default: 0.5
Set Up Displays