Installing the TMD
Thermo Fisher Scientific
Installing the TMD
2-13
REC-4105 Rev L
POS FUNCTION
ON
OFF
1 Password
protection
Enable password protection software.
Eliminate password.
2 Speed sensor input
Enable speed sensor input option.
Speed sensor disabled.
3 SYNC input
Enable SYNC input on the slaves for
synchronization of transmitter pulses.
(Required when two detectors are within 30
ft of each other.)
SYNC input disabled.
(Required setting on the
master.)
4 Belt
direction
Reversed
Normal
5 Factory
test
Normal operation.
(Required setting.)
6 Units
selection
Metric
English
7 F5
Enable F5 error alarm
Disables F5
8 Cold start
Enable cold start on power up.
Cold start disabled.
Table 2–1.
SW1 DIP Switch Settings
Four switches on the CPU board must be set for power, line voltage, and
alarm output for the TMD. If RS-485 communication is supported, a
fifth switch must also be set.
Figure 2-4 shows the locations of the switches on the CPU board.
Table 2-2 and Table 2-3 describe the functions of the switch settings.
CPU Board Switch
Settings
Содержание Oretronic III
