Thermo Scientific Oretronic III, Руководство по эксплуатации и обслуживанию

Страница: 47 / 152

Thermo Fisher Scientific Operating the TMD 3-1
REC- 4105 Rev L
Chapter 3 Operating the TMD
This chapter provides information about setting up and operating the
Oretronic III TMD. The operator interface, including all keys,
indicators, and displays, is described. Procedures for initial setup and
calibration are provided.
You operate the Oretronic III TMD through the control unit. The
control unit is mounted locally, but it may be operated either locally or
remotely. Remote operation uses a second front panel, identical to the
one on the control unit that is connected to the control unit. Operations
are performed from the remote front panel.
You can optionally connect the control unit to a Modbus
communications network to set up and operate the TMD. This method
of remote control uses Modbus protocol for reading and writing detector
registers.
The TMD is a dual-language instrument. All measure units can be either
English units or Metric units, as selected by the SW1 DIP Switch. (This
chapter uses English units.) If you change your units’ selection after the
TMD is set up and calibrated, you must redo the calibrations and setup
using the new units; the TMD will not convert values.
The operator interface to the TMD is a front panel on the control unit.
The front panel is composed of a touch panel keypad, LED indicators,
an eight character alphanumeric display, and a three-digit counter LED.
Figure shows the front panel.
Note
: To simplify the descriptions in this section, the alphanumeric
display will be called “the display” and the counter LED will be called
“the counter.”
This section describes the components of the front panel and how they
are used to set up the TMD.
Overview
Operator
Interface