Thermo Scientific Oretronic III, Руководство по эксплуатации и обслуживанию

Страница: 123 / 152

Thermo Fisher Scientific B- 9
REC 4105 Rev L
4. Wire the HOT input power to the terminal labeled “H.”
5. Wire the NEUTRAL input power to the terminal labeled “N.”
Note
: Make sure the chassis cover is closed before applying power.
6. Put the POWER switch on the chassis cover in the “ON” position.
There are four DIP Switches on the inside of the enclosure door that
must be set correctly for the remote front panel. These switches
correspond to the SW4 Comm switches on the CPU board of the main
TMD.
The Comm switches must be set on both SW4 and the remote front
panel. Refer to Table B-1 for the correct switch settings to support the
remote front panel.
* Setting for TMD remote front
Table B–1. Comm Switch Settings
The remote front panel uses the setup and calibration parameter settings
of the main TMD control unit. To support the remote front panel, the
remote? parameter in the control unit must be set to y.
Because the operator interface provided by the remote front panel is
identical to that provided by the TMD control unit, all operations are
performed identically. Refer to Chapter 3 for a complete description of
the operator interface and information about operations. Refer to
Chapter 4 for information about troubleshooting procedures.
Note
: If the main TMD control unit is in use, the display on the remote
front panel will show busy if you try to use it. You will not be able to
use the remote until 30 seconds after the control unit is no longer in use.
Setting the
Comm
Switches
POS FUNCTION ON OFF
1 & 2 Configures RS-485
communication.
2-wire RS-485 * 4-wire RS-485
3 Connects a termination
resistor across the
receive input.
* Termination ON Termination OFF
4 Not used
Setting up and
Operating the
Remote Front
Panel