Thermo Scientific Oretronic III, Руководство по эксплуатации и обслуживанию

Страница: 60 / 152

Operating the TMD
3-14 Operating the TMD Thermo Fisher Scientific
REC-4105 Rev L
These screens allow you to test the indicators and keys on the front
panel.
The first test screen is LAMP? N. Changing this to LAMP? Y and
pressing ENTER tests the indicators by lighting each LED on the front
panel individually. The bar graph segments light from the bottom up
and the counter counts up from 000 to 999. This test completes
automatically.
The second test screen is KEY? N. Changing this to KEY? Y and
pressing ENTER initiates the key test. When you press ENTER, the
display shows ENTER. When you press the up VALUE key, the display
shows V UP, and so on. Each key press should result in a corresponding
display. To end the key test and return the keys to their normal
functionality, press RESET.
This screen shows the version of TMD software installed. The display
shows V XX.XX, where XX.XX is the version number.
This screen allows you to exit the setup screens and return to Run mode
without having to SCROLL back up to the Run screen. The display
shows EXIT?. To exit, press ENTER.
The TMD has built-in error detecting that recognizes and reports error
and fault conditions in the system.
When an error occurs, the ALARM LED lights and the error message
appear on the display. The display shows the type of error that occurred
(refer to Table 3 1: Error Messages). The counter shows the
corresponding error number. An E in the first digit of the counter
indicates an error rather than a fault condition.
To clear an error message from the Run screen, press the ENTER key.
Correct the error condition, scroll to the error message display (the last
display in the scroll), and press ENTER to clear the message.
Front Panel Tests
Software Version
Exit
Error Messages
Error Conditions