Chapter 6: Operation
Thermo Scientific iEMS Incubator / Shaker HT User Manual Rev. 2.4, Cat. no. 1506400A
24
6.4
Normal operation
6.4.1
Placing the microplate
Caution:
To minimize the possibility of splashing, aerosols and evaporation
during shaking and incubation, it is recommended you use microplate
sealers.
Open the cover of the thermal microplate holder and place the microplate into
the thermal microplate holder so that well A1 is located in the upper left corner
as shown in Fig. 6.2.
Caution:
Do not handle the thermal microplate holder from its cover since it will
come off. Use the handle (Fig. 6.2).
Caution:
Do not place the microplate holder into the instrument while the
instrument is shaking. This may damage the shaking mechanism.
Fig. 6.2 Microplate in the thermal microplate holder
Be careful not to spill the contents of the microplate when you load it into the
thermal microplate holder and when you insert the holder into the slot.
Carefully insert the plate into the microplate holder and close the cover.
Caution:
The covers of the thermal microplate holders are not spring-loaded, but
you should take care not to trap your fingers when closing the cover of
the holder. Avoid bumping the microplate holder while inserting it into
the slot.
A1
Handle
Содержание iEMS Incubator
