TK 61555-2-MM-EN
97
Figure 77.
Hex Drive Type Bellows Seal
1.
O-ring (Inside Bellows)
2.
Hex Drive
3.
Seal Faces
4.
Hard Ring
5.
O-ring (In Seal Plate)
6.
Bellows
N
NO
OT
TIIC
CE
E
E
Eq
qu
uiip
pm
me
en
ntt D
Da
am
ma
ag
ge
e!!
O
Oiill a
ap
pp
plliie
ed
d tto
o tth
he
e sse
ea
all ffa
acce
ess m
mu
usstt b
be
e a
ab
bsso
ollu
utte
elly
y cclle
ea
an
n..
14. Remove the yellow protective cap. Clean the hard ring and the primary ring (bronze ring) with
the alcohol wipes found in package labeled “1”. Clean the polished mating surfaces of both
rings with the lint free dry wipes from package number “2”. Apply clean compressor oil to the
polished surfaces of the seal, the lip seals, and the seal plate gasket from the package number
“3” before assembling.
15. Install the seal plate and gasket to the compressor body. Do not bump the seal hard ring on
the end of the crankshaft during assembly.
16. Install the seal plate mounting bolts and washers. Torque the seal plate bolts to 38 N•m (28 ft-
lb) in two steps using a criss-cross pattern.
17. Install the mounting flange and torque the bolts to 38 N•m (28 ft-lb) in two steps using a criss-
cross pattern.
18. Install the compressor in the unit.
Condenser Coil
Removal
1.
Recover the refrigerant charge.
2.
Remove the condenser grille and belt panel.
3.
Unsolder the inlet and outlet refrigeration line connections from the copper stub tubes on the
micro-channel condenser coil. Use a heat sink on the copper stub tubes.
