94
TK 61555-2-MM-EN
plate.
N
No
otte
e:: Provide a clean soft surface for hard ring to fall onto when pushed out of the seal plate.
5. Remove the small lip seal from the seal plate, but do not remove the larger, internal lip seal
unless it is damaged.
6. Remove the bellows assembly from the shaft by prying evenly on each side with small pry
bar.
7. Retain all old seal parts for warranty return if required.
8. Clean all parts thoroughly to remove all oil and gaskets.
9. Polish the crankshaft with crocus cloth if it is rusted or dirty. Do not allow abrasives to
contaminate the compressor.
10. Install the new lip seal in the seal plate with the lip side facing out and the flat side facing
toward the compressor.
Figure 72.
Lip Seal Installation
1.
Lip Side Facing Out
2.
Flat Side Toward Compressor
N
NO
OT
TIIC
CE
E
E
Eq
qu
uiip
pm
me
en
ntt D
Da
am
ma
ag
ge
e!!
D
DO
O N
NO
OT
T tto
ou
ucch
h o
orr d
da
am
ma
ag
ge
e tth
he
e p
po
olliissh
he
ed
d sse
ea
all ffa
acce
e ssu
urrffa
acce
ess o
on
n tth
he
e h
ha
arrd
d rriin
ng
g.. K
Ke
ee
ep
p tth
he
e
p
prro
otte
eccttiiv
ve
e cca
ap
p iin
n p
po
ossiittiio
on
n o
on
n tth
he
e b
be
ellllo
ow
wss u
un
nttiill ffiin
na
all a
asssse
em
mb
blly
y..
11. Apply clean compressor oil to the new O-ring and install it in the seal plate. Apply clean
compressor oil to the new hard ring. Verify the hard ring installation tool (P/N 204-953) is
clean. Use the hard ring installation tool to push the hard ring (with the polished surface
toward the installation tool) fully into the seal plate. Do not pinch the O-ring.
N
No
otte
e:: If the installation tool is not available, use the pad in the new seal packaging to protect
the polished surface of the hard ring during assembly.
