Thermo King 914970, Руководство пользователя

Страница: 54 / 186

Electronic Controls
54
Guarded Access Mode
The TG-V controller is pre programmed at the
factory to match the standard configuration and
operating requirements of the unit.
If the controller is being replaced, the
programming set-up codes must be set to match
the configuration of the unit.
The factory programming set-up codes can be
found on the schematic and wiring diagrams for
the unit. Special changes in the programming can
be made for specific special applications.
Programming
Programming is done through the Guarded Access
mode.
The Guarded Access mode consists of 5 screens
numbered 1 through 5. Screen numbers are
indicated by a 1/2 size digit.
The Microprocessor Controller is programmed by
entering a two digit set-up code into each screen.
Set-up code 68 is the standard set-up code for
Screen 1 on CD-II MAX (NAD) units.
Programming the controller requires the
following:
• Choosing the desired set-up code for each
screen.
• Entering the Guarded Access mode.
• Changing the set-up codes as required.
Choosing Set-up Codes
The standard set-up codes for the CD-II MAX are
shown at the left.
NOTE: The set-up code for Screen 3 can be
determined by checking the sensors themselves.
Each two digit set-up code can represent several
operational settings of the Thermo King unit.
The factory programming set-up codes can be
found on the schematic and wiring diagrams for
the unit.
If the set-up codes are not available, they can be
determined using information shown later in this
chapter.
Thermostat Set-Up Codes
Left Digit Right Digit Screen
USA EEC
6 8 9 1
1 1 1 2
0 0 0 3
0 0 0 4
0 1 1 5