Service Manual for the Thermador Professional Series Rangetop, Model PCG366G
58300000151625_ARA_EN_B
Page 19 of 34
4.2.2 Jet Holder Assembly Removal and Replacement
This procedure is for removing the jet holder assembly from the
burner support rail, in the event that a jet holder assembly needs
replacing.
Sharp Components – Gloves Recommended
■ The burner support rail may have sharp edges. Avoid injury by
handling with care.
■ It is recommended to use gloves when removing or installing the
burner support rail.
1. Follow all safety precautions and steps in the
2. Follow all steps in
Jet Holder Assembly and Burner Support Rail
3. Remove the wire guard clip from each jet holder assembly prior to
removing the jet holder assembly from the burner support rail (see
Figure 22).
NOTE:
The jet holders are secured to the burner support rails with
a tight fit.
4. As necessary, use a flat-bladed screwdriver to pry the jet holder
assembly out until the alignment boss is disengaged from the
circular receptacle on the burner support rail. Then rotate the jet
holder assembly (gloves recommended) until it can be removed
through the corresponding grooves in the burner support rail
(see Figure 22 and Figure 23).
-OR-
Alternatively, use a slip joint pliers and gloves to disengage the
alignment boss and rotate the jet holder assembly until it can be
removed (see Figure 22 and Figure 23).
Figure 22: Jet Holder Assembly – Detaching Alignment Boss from Rail
Figure 23: Jet Holder Assembly – Rotating and Removal from Rail
Alignment boss
Wire guard clip
