Service Manual for the Thermador Professional Series Rangetop, Model PCG366G
58300000151625_ARA_EN_B
Page 18 of 34
4. Push each ignition wire downward through its respective
receptacles in the burner support rail.
5. Make note of burner support rail placement on the rangetop
chassis (before removing the rails) so you can re-install afterwards
in the correct position.
NOTE:
It is important to reinstall the correct burner support rails in
the correct position in order to correctly match up the jet holder
assemblies to the gas tubes.
Sharp Components – Gloves Recommended
■ The burner support rail may have sharp edges. Avoid injury by
handling with care.
■ It is recommended to use gloves when removing or installing the
burner support rail.
6. Using a large flat-blade screwdriver, push one side of the burner
support rail to the other side of the chassis, until the 2 prongs
come out from their slots on the chassis (see Figure 20). Then
remove burner support rail with the two jet holder assemblies
attached (see Figure 21).
Gas Leaks
Carefully check for gas leaks at each gas component that was
removed, replaced, or otherwise serviced using a gas leak detector or
bubble test.
Figure 20: Removing Burner Support Rail from Rangetop Chassis
Figure 21: Burner Support Rail with Jet Holder Assemblies Attached
