Thermador Professional PCG366G/03, Руководство по обслуживанию

Страница: 17 / 34

Service Manual for the Thermador Professional Series Rangetop, Model PCG366G
58300000151625_ARA_EN_B
Page 17 of 34
1. Carefully lift and remove the two heat shields (see Figure 17).
Figure 17: Removing the Heat Shield
4.2 Component Removal and Replacement
4.2.1 Jet Holder Assembly and Burner Support Rail Removal
and Replacement
This procedure is for the removal of the burner support rail with the jet
holder assemblies attached, which may be necessary in order to gain
access to components for servicing. If a jet holder assembly needs to
be removed from the burner support rail or needs to be replaced, see
Jet Holder Assembly Removal and Replacement , page 19 .
Figure 18: Burner Support Rail
1. Follow all safety precautions and steps in the Preparing the
Rangetop for Servicing , page 14.
2. Using a 9/16 inch wrench, unscrew the hex nuts to remove the
gas tubes from the jet holder assemblies. Be careful not to bend
the gas tubes (see Figure 19).
Figure 19: Removing Gas Tube from Jet Holder Assembly
3. Using a 9/16 inch wrench, unscrew the hex nut to remove the
other end of the gas tubes from their respective valve as follows:
■ [Left-side XLO valves]: While using a ½ inch wrench to hold
the bolt on the solenoid valve, unscrew the gas tube hex nut
with a 9/16th wrench. Be careful not to bend the gas tube (see
Figure 31).
■ [Right side and middle standard valves]: Using a 9/16 inch
wrench, remove the gas tubes from the standard valves. Be
careful not to bend the gas tube.