Thermador PRG486JDG/01, Руководство по обслуживанию, Страница: 68 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 69 of 92
6.9.3.2 Removing the Bulb
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 22.
2. Remove the oven racks.
3. While supporting the lens with one hand, insert a flat-blade
screwdriver into the groove for the holder clip, and press down
gently while rotating the screwdriver. This releases the clip, so that
you can pull out the lens out from that side (without removing the
holder clip from the housing). See Figure 103 and Figure 104.
4. On the other side of the lens, gently pull it out from underneath the
fixing clip, without removing the fixing clip from the housing.
Figure 104: Releasing the Lens from the Holder Clip
5. Remove the bulb by carefully pulling it straight out to ensure its
two prongs do not break off inside the lamp holder (socket).
6. When installing a Halogen bulb, to prevent premature burn-out of
the bulb, never handle it with bare hands. Handle the bulb with
clean, dry gloves, or a clean, dry tissue or cloth.
6.9.3.3 Removing the Lamp Assembly
1. Follow all safety precautions and steps in Preparing the Range for
Servicing , page 22 .
2. Follow all steps in Accessing Components under the Maintop ,
page 22 .
3. Remove the griddle / grill assembly (see Griddle / Grill Removal
and Replacement, page 27).
4. Locate the oven lamp wire connector for the lamp assembly you
want to replace, then detach the wire connector, which is located
under the griddle (see Figure 105).
Figure 105: Wire Connectors for an Oven Lamp Assembly
5. Remove oven door (see Oven Door Removal, Installation, and
Alignment, page 70).
NOTE: It is recommended to remove the door, to prevent weight
or force applied from damaging the door and latch components.
6. Remove the oven trays.