Thermador PRG486JDG/01, Руководство по обслуживанию, Страница: 40 / 91

Service Manual for the Thermador Pro Grand Next Generation 48-Inch Natural Gas and LP Gas Ranges, Models:
PRG486JDG/01, PRL486JDG/01
58300000159722_ARA_EN_D
Page 41 of 92
3. Remove all knobs from their respective valve stems by slowly
pulling the knobs straight out, away from control panel.
4. Remove the backguard (see Backguard Removal and
Replacement, page 61) .
5. Remove the control panel (see Control Panel Removal and
Replacement, page 32) .
6. Detach all wire connectors to the LED indicators, temperature
gauge, potentiometers, solenoid valves, and microswitches - and
make a note of how all the wires are connected.
NOTE: It is always recommended to label and tag all wires, wire
connectors and harnesses prior to disconnecting them, so as to
correctly identify their connections/locations when reassembling.
Alternatively, you can photograph the wire connections prior to
disconnecting (for example, with your mobile phone).
7. At each of the locations shown in Figure 33 on page 32, remove
and retain the two screws inside each bezel (see Figure 52) in
order to detach the manifold support brackets at the back of the
control panel (see Figure 54, page 42).
Figure 52: Bezel Screws Attached to Manifold Support Bracket
1 Screws (2) attached to manifold support bracket
Figure 53: Manifold Support Bracket (Shown with Control Panel
Removed)
1 Manifold
2 Bezel screw locations (2)
8. Remove the burner support rail(s) with jet holder assemblies
attached by following the steps in Removing the Burner Support
Rail, page 25.