79
GB
8. Control commands
The following control commands are available with the management remote
control SendoPro 868-A:
Programming mode
Activating the programming mode
Teach-in channel A
The actual measured brightness value is applied to the brightness
level channel A.
Transfer is made to current active brightness set point value. That is,
if the alternative brightness set point value is switched to, the current
measured brightness value [lux] is transferred to the alternative
brightness set point value via the teach-in command.
The value transfer is not carried out if the measured brightness value
is outside the value range of the brightness set point value (displayed
via LED).
Master/Slave?
The operating mode master or slave can be determined using the
remote control. Is the request consistent with the setting in the
presence detector, does the detector confirm this with a flicker for 3
s. Is the request not consistent, the LED lights up briefly.
Switching light
The switching output light can be switched on and off.
Select <On> or <Off> with the function keys.
Test presence
See chapter 7.1 page 75
Test lighting
See chapter 7.2 page 77
Restart
The detector restarts. Setting values are retained.