Thales DVOR 432, Техническое руководство

Страница: 110 / 234

DVOR 432
Installation Operation and Maintenance
4-6
Ed. 01.04
d) Performlogin procedure at the PC. Acknowledge "User1, Level 5" with OK button.
e) Click on screen button Control in the Main Status window. The 'RC Management' window appears.
f) Click on pulldown menu File Transfer . Select command Copy PC File to RAM .
g) Copy configuration files ( *.sit, *.lke, *.ptt, *.oio ) fromPC to the site.
Service activity only: Copy activities mask files for the first setup (*.mxn) from PC to site.
h) Click command Reset Site of menu File Transfer to activate entered files and data.
NOTE: The Adracs Remote Controlling Software is closed due to the reset. It has to be restarted
manually.
i) Run ADRACS again. PerformLogin.
k) Click screen button
Control in the Main Status window.
l) Select DateTimeREU in 'RC Management' window. Enter date and time in 'Date&Time REU' winĆ
dow and confirmwith button SetNew . Close 'Date&Time REU' window. Proceed with 4.2.5 c) or
m)Logout from ADRACS by clicking on Logout button in 'RC Management' wndow and then click
on Exit button. The ADRACS application is closed.
4.2.4 Use of Main MenuItems and Activities Masks
From the Main Menu in ADRACS program the items Commands (C) and Activities (A) are used in the
alignment procedure of the first setup. Following activities masks are available, composed of different
data sets (listed in section 4.3 of Technical Manual ADRACS , Ref. No. 83140 55324):
- Configuration (CF) - Error Curve (EC)
- Antenna Adjustment (AA) - Alarm Limits M1 (AL1)
- Test Generator (TG) - AlarmLimits M2 (AL2)
- TX1 settings (TS) - Battery/BCPS (BAT)
- Monitor Calibration (MC) - Flight Check2 (FC)
4.2.5 Entering Station Configuration Data
a) Run Adracs Remote Controlling Software, see section 4.2.3, steps a) to c).
b) Performlogin procedure at the PC.
c) Click on screen button
select in the DVOR status field. The 'Detailed Status' window appears.
d) Select menu Commands . Click on commands Switch both TX ON and Set both MON Bypass ON .
e) Select menu Activities in Main menu and select activities mask 'Configuration'.
f) Enter station type, station frequency and identity morse code for both transmitters and monitors
in the TX1/2 and MON1/2 window.
g) Verify that the MON1/2-window single channel mode is off.
h) Select menu
Command s. Click on command Switch both TX OFF .