Textron Bell 206A Series, Руководство по обслуживанию

Страница: 98 / 234

BHT-206A/B-SERIES-MM-1
5-00-00
Page 68
Rev. 14 30 APR 2013 Export Classification C, ECCN EAR99
d. Verify for clearance between governor stop and lever
stop arm.
e. Lower collective stick full down.
f. Position N
2
governor actuator to full DECREASE
(extended).
g. Verify for clearance between governor stop and lever
stop arm.
Chapter 71 h. Verify control linkage for excessive looseness, lost
motion, and binding.
i. Remove the starter generator and examine the
bearings for smooth rotation. Examine the splines on the starter
generator driveshaft and the mating splines on the engine gear
shaft for wear. If dry spline starter generator installed, clean
splines and lubricate.
Chapter 71 and
Chapter 12 16. Examine N
1
and N
2
tachometer generator shaft splines
and gearbox adapter splines for condition. Clean and lubricate
shaft splines.
FUEL SYSTEM
AIRFRAME FUEL FILTER
Chapter 28 1. Replace airframe fuel filter element, kit KD651511, element
52-01103-1, or element 7582301, as applicable.
a. Inspect filter head as follows:
b. Remove outlet port fitting from filter head. Using a
0.020 inch (0.508 mm) wire, pass wire through bleed hole in
outlet port side of filter head to ensure that hole is unobstructed
(applicable to fuel filter assemblies 306001, 306005,
222-366-621-001, -003, and -101, 52-2889-016, and
52-2889-016A).
c. Purge airframe fuel filter and engine fuel system.
PROGRESSIVE INSPECTIONS
5-23. 300-HOUR AIRFRAME PROGRESSIVE INSPECTION — EVENT NO. 3 (CONT)
DATA REFERENCE INSPECTION TASK DESCRIPTION
INITIAL
MECH OTHER