DAC and ADC GUI Configuration File Changes When Using a Xilinx Development Platform
28
SLAU580B – June 2014 – Revised September 2016
Copyright © 2014–2016, Texas Instruments Incorporated
TSW14J10 FMC-USB Interposer Card
Figure 21. LMK04828 Address 0x110
Open the HSDC Pro GUI, select the
ADC
tab, then select “ADC12J4000_BYPASS” using the device drop-
down arrow. After the firmware is loaded, make sure the
Analysis Window (samples)
is no greater than
65,536 (due to the limit of the internal FPGA memory used for this capture). Next enter "2G" in the
ADC
Output Data Rate
window.
Click the
Capture
button.
The GUI will display the new lane rate and JESD reference clock required by the capture platform FPGA,
as shown in
Click the
OK
button.
Figure 22. HSDC Pro GUI
