Software Start Up
11
SLAU580B – June 2014 – Revised September 2016
Copyright © 2014–2016, Texas Instruments Incorporated
TSW14J10 FMC-USB Interposer Card
4.2
USB Interface and Drivers
Connect a USB cable between J3 of the TSW14J10EVM and a host PC.
Click on the High Speed Data Converter Pro icon that was created on the desktop panel or go to
"C:\Program Files (x86)\Texas Instruments\High Speed Data Converter Pro" and double click on the
executable called
High Speed Data Converter Pro.exe
to start the GUI.
The GUI first attempts to connect to the EVM USB interface. If the GUI identifies a valid board serial
number, a pop-up opens displaying this value, as shown in
. It is possible to connect several
TSW14J10 EVMs to one host PC but the GUI can only connect to one at a time. In the case where
multiple boards are connected to the PC, the pop-up will display all of the serial numbers found. The user
then selects which board the GUI will be associated with.
Figure 4. TSW14J10EVM Serial Number
Click on the
OK
button to connect the GUI to the board. The top-level GUI opens and appears as shown
in
Figure 5. High Speed Data Converter Pro GUI Top Level
If the message
No Board Connected
opens, double check the USB cable connection. If the cable
connection appears fine, try establishing a connection by clicking on the
Instrument Option
tab at the top
left of the GUI and select
Connect to the Board
. If this still does not correct this issue, check the status of
the host USB port.
