Teufel Impaq 300 Blu-ray, Техническое описание и инструкция по эксплуатации

Страница: 21 / 28

• Impaq
®
300 Blu-ray 21
Radio playback
Select the source “Radio”
• Push the button 29 “RADIO” to select radio mode.
Setting the radio stations
You can set the tuning frequency directly using the
number buttons or increase or decrease the tuning fre-
quency in increments with the buttons
56 “ Tune– /
Ï
” and
40 “ Tune+ /
Å
”.
• Set the frequency automatically : After pushing and
holding (for approx. 2 seconds) the button 56 “ Tune–
/
Ï
” or 40 “ Tune+ /
Å
”, station scanning starts in the
desired direction until a station with a suffi cient signal
is found.
• Set the frequency manually : Each time you tip the
button 56 “ Tune– /
Ï
” or 40 “ Tune+ /
Å
” increases or
decreases the frequency by one increment (FM: 0.05
MHz, AM: 9 kHz).
The set frequency is displayed on the display panel 3 . If
the station transmits an RDS signal, the name of the sta-
tion is displayed shortly instead of the frequency. With
the button
43 “ RDS” you can access additional RDS infor-
mation if the radio station provides such information.
Station memory
Your radio can save up to 39 stations. You can conven-
iently select the stations with the push of a button.
Saving stations automatically
• Push the button 49 “Auto Scan”.
The radio will now search for stations with a suffi cient
signal and save them automatically. Previously saved
stations are deleted in the process.
• If more than 39 stations have been found, the message
“FULL” will appear on the display panel and scanning
terminates.
Saving stations manually
1. Set the desired station as described above.
2. Push the button
11 “PRO” or the button 45 “Program”. A
memory slot number will appear on the display panel.
3. Directly enter the desired memory slot number with the
number buttons.
4. End the saving process by pushing the button 11 “PRO”
or the button 45 “Program” again.
The station has now been stored. The device will return to
normal operation after fi ve seconds of button inactivity.
Selecting stations from the memory
You can access the stations saved in the memory con-
secutively with the buttons
39 “
▲
/” and 55 “
▼
/
Preset–”.
Stereo/Mono
Stations with a weak signal may cause faults in stereo
mode. In this case, switch to mono mode by pushing the
button
53 “Stereo/Mono”.
53
49
55
56
39
29
40
41
43
45
11 3
Auto Scan Level
91768 GB 20120611.indd 21 91768 GB 20120611.indd 21 11.06.12 09:41 11.06.12 09:41