FF711BG
7-3
Tetra Pak
Hoyer
Fig. 7.1
Fig. 7.2
7.2.2 Daily
•
Rinse the machine thoroughly with water and/or
washing solutions before starting production;
•
Wash the machine at the end of the production
shift, proceed in the following way:
-
disconnect the machine from the filling line;
-
connect the washing pipe to the pump inlet,
proceed with the washing;
FEEDER
Remove the screw (Part.1, Fig.7.1), open the door
(Part.2, Fig.7.1) and pull out the screw feeder
(Part.3, Fig.7.1).
Lift the hopper lid (Part.1, Fig.7.2), lift the safety
grid (Part.2, Fig.7.2), move the rod (Part.3,
-
at the same time, to pour the washing
solution (by the small quantities) inside of
the primary hopper. In this way washes the
agitator (Part.4, Fig.7.2) and the screw
feeder (Part.3, Fig.7.1).
materials required: water - detergent -
disinfectant.
7.2.3 Monthly
•
Check the oil level in the reduction gears;
material required: IP Mellana 320 oil.
•
Check the screw feeder transmission chain
tension.
•
Wash the feeder and the ice-cream line carefully,
proceed on the following way:
Fig.7.2) and pull out the mixer (Part.4, Fig.7.2).
Wash and disinfect the various components and the
hoppers (main and secondary), then reassemble,
lubricating the gaskets as required.
1
2
3
3
1
2
4
RETURN TO PM
