Terex Genie Z-33/18, Руководство по обслуживанию и ремонту

Страница: 32 / 117

3-10 Z ® -33/18 Part No. 1268514GT
January 2020 Section 3 • Repair Procedures
8 Momentarily activate the drive enable toggle
switch in the right direction until THRESHOLD
is shown on the display.
9 Momentarily activate the steer rocker switch in
the right direction until RAMP DOWN TIME is
shown on the display.
10 Momentarily activate the drive enable toggle
switch in the right direction to enter RAMP
DOWN TIME calibration mode.
11 Press down on the foot switch and momentarily
activate the function to be corrected.
Result: The display will show the function,
direction and the actual stored value.
12 Press down on the foot switch, start a timer
and activate the same function in the same
direction. Note how long it takes the function to
reach maximum speed. This is the ramp down
time.
13 Compare the function ramp down time with the
table on the right and determine whether the
ramp up time needs to increase or decrease.
14 To adjust the ramp down time setting, release
the foot switch. Momentarily move the steer
rocker switch in the right direction to increase
or momentarily in the left direction to decrease.
Each time the steer rocker switch is momentarily
pressed, the time will change in 0.1 second
increments.
Changing the ramp up time setting in one direction
will also change the opposite direction.
PLATFORM CONTROLS
15 When ramp time has been achieved, activate
the drive enable toggle switch to the right to
save your changes.
Result: The alarm should sound indicating the
setting has been saved.
16 Repeat steps 11 through 13 for each machine
function.
To exit programming mode:
17 Move and hold the drive enable toggle switch in
the left direction until the display screen returns
to
SYSTEM READY .
Ramp down time (factory
settings)
Primary boom up/down
decelerate 1,5 second
Secondary boom up/down
decelerate 0,65 second
Turntable rotate
decelerate 0,25 second
Extend/Retract
decelerate 0,5 second