Terex Genie Z-33/18, Руководство по обслуживанию и ремонту

Страница: 31 / 117

January 2020
Part No. 1268514GT Z
®
-33/18 3-9
Section 3 • Repair Procedures
PLATFORM CONTROLS
15 When ramp time has been achieved, activate
the drive enable toggle switch to the right to
save your changes.
Result: The alarm should sound indicating the
setting has been saved.
16 Repeat steps 11 through 13 for each machine
function.
To exit programming mode:
17 Move and hold the drive enable toggle switch in
the left direction until the display screen returns
to
SYSTEM READY .
Ramp up time (factory settings)
Primary boom up/down
accelerate 1 second
Secondary boom up/down
accelerate 1 second
Turntable rotate
accelerate 1 second
Extend/Retract
accelerate 0,5 second
The ramp down time setting of a function controls
the time at which it takes for the function to come
to a complete stop, when returned to the neutral
position. The ramp down time of a function can be
changed to compensate for hydraulic pump wear
to maintain peak performance from the machine.
Begin this procedure with the rotary speed control
at the platform turned fully in the clockwise
direction.
1 Turn the key switch to platform control.
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Do not press down the foot switch.
4 Move and hold the drive enable toggle switch in
the right direction while holding the steer rocker
switch in the right direction.
5 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer rocker switch.
Result: The display will show FAULTS .
6 Momentarily activate the steer rocker switch in
the right direction until SETTINGS is shown on
the display.
7 Momentarily activate the drive enable toggle
switch in the right direction until VALVE AND
PUMP SETTINGS is shown on the display.